GitSwarm-EE 2017.2-1 Documentation


Time Tracking

Introduced in GitLab 8.14 in beta.

Time Tracking allows you to track estimates and time spent on issues and merge requests within GitLab.

Overview

Time Tracking lets you:

You don't have to indicate an estimate to enter the time spent, and vice versa.

Data about time tracking is shown on the issue/merge request sidebar, as shown below.

Time tracking in the sidebar

How to enter data

Time Tracking uses two slash commands that are available with this new feature: /spend and /estimate.

Slash commands can be used in the body of an issue or a merge request, but also in a comment in both an issue or a merge request.

Below is an example of how you can use those new slash commands inside a comment.

Time tracking example in a comment

Adding time entries (time spent or estimates) is limited to project members.

Estimates

To enter an estimate, write /estimate, followed by the time. For example, if you need to enter an estimate of 3 days, 5 hours and 10 minutes, you would write /estimate 3d 5h 10m. Time units that we support are listed at the bottom of this help page.

Every time you enter a new time estimate, any previous time estimates will be overridden by this new value. There should only be one valid estimate in an issue or a merge request.

To remove an estimation entirely, use /remove_estimate.

Time spent

To enter a time spent, use /spend 3d 5h 10m.

Every new time spent entry will be added to the current total time spent for the issue or the merge request.

You can remove time by entering a negative amount: /spend -3d will remove 3 days from the total time spent. You can't go below 0 minutes of time spent, so GitLab will automatically reset the time spent if you remove a larger amount of time compared to the time that was entered already.

To remove all the time spent at once, use /remove_time_spent.

Configuration

The following time units are available:

Default conversion rates are

Other interesting links: