P4DEBUG

Description

Set Perforce server or proxy trace options.

Usage Notes

Used by Client?

Used by Server?

Command-Line Alternative

Can be set in P4CONFIG file?

No

Yes

None

No

Value if not Explicitly Set

Operating System

Value

All

As of Release 2011.1, server=1 is the default setting.

Examples

server=0

server=1

server=2

server=3

Notes

To disable logging, set P4DEBUG to server=0.

Higher settings for the Perforce server trace options are useful only to administrators working with Perforce Technical Support to diagnose or investigate a problem.

The preferred way to set trace options for the Perforce server (or proxy) is to set them on the p4d (or p4p) command line. For technical reasons, this does not work for sites running Perforce servers or proxies as services under Windows. Administrators at such sites can use p4 set to set the trace options within P4DEBUG, allowing the service to run with the options enabled.

Setting server debug levels on a Perforce server (p4d) has no effect on the debug level of a Perforce Proxy (p4p) process, nor on downstream replicas or edge servers.

For further information about server trace options, see the Perforce Server Administrator's Guide: Fundamentals.