Perforce 2006.1 Command Reference
<< Previous Chapter
p4 fixes
Table of Contents
Index
Perforce on the Web
Next Chapter >>
p4 fstat

p4 flush

Synopsis

Update a client workspace's have list without actually copying any files.

Syntax

p4 [g-opts] flush [-n] [file[revRange]...]

Warning

Using p4 flush incorrectly can be dangerous.

If you use p4 flush incorrectly, the server's metadata will not reflect the actual state of your client workspace, and subsequent Perforce commands will not operate on the files you expect! Do not use p4 flush until you fully understand its purpose.

It is rarely necessary to use p4 flush.

Description

p4 flush performs half the work of a p4 sync. Running p4 sync filespec has two effects:

p4 flush performs only the second of these steps. Under most circumstances, this is not desirable, since a client workspace's have list should always reflect the client workspace's true contents. However, if the client workspace's contents are already out of sync with the have list, p4 flush can sometimes be used to bring the have list in sync with the actual contents. Since p4 flush performs no actual file transfers, this command is much faster then the corresponding p4 sync.

Use p4 flush only when you need to update the have list to match the actual state of the client workspace. The Examples subsection describes two such situations.

Options

-n

Display the results of the flush without actually performing the flush. This lets you make sure that the flush does what you think it will do before you do it.

g-opts

See the Global Options section.

Usage Notes

Can File Arguments Use
Revision Specifier?

Can File Arguments Use
Revision Range?

Minimal Access Level Required

Yes

Yes

read

Unfortunately, this is not a complete remedy, since any file revisions that were deleted from the have list by p4 flush will remain in the client workspace even after the p4 sync -f. In this case, you will need to manually remove deleted file revisions from the client workspace.

Examples

Since p4 flush moves no files across the slow link, the process can be much faster then running the same p4 sync command ten separate times.

and a View: of

He decides that all the files under /usr/joe/project1 need to be included in the workspace, and accomplishes this by using p4 client to change the Root: to

and the View: to

This keeps his current client workspace files in the same place, while extending the scope of the workspace to include other files. But when Joe runs his next p4 sync, he's surprised to see that Perforce deletes every non-open file in the client workspace and replaces it with an identical copy of the same file!

Perforce behaves this way because the have list describes each file's location relative to the client root, and the physical location of each file is only computed when each Perforce command is run. Thus, Perforce thinks that each file has been relocated, and the p4 sync deletes the file from its old location and copies it into its new location.

To make better use of Perforce, Joe might have performed a p4 flush #have instead. This would have updated his client workspace's have list to reflect the files' "new" locations without actually copying any files.

Related Commands

p4 flush is an alias for p4 sync -k

p4 sync -k

To copy files from the depot to the client workspace

p4 sync

To bring the client workspace in sync with the have list after a bad p4 flush

p4 sync -f


Perforce 2006.1 Command Reference
<< Previous Chapter
p4 fixes
Table of Contents
Index
Perforce on the Web
Next Chapter >>
p4 fstat
Please send comments and questions about this manual to [email protected].
Copyright 1999-2006 Perforce Software. All rights reserved.
Last updated: 06/23/06